Skip to content
Guides & References

Dell connection templates

The Dell templates in rconfig/rConfig-templates v2.2.2: Force10 FTOS, Dell Networking and PowerConnect, and the line ending FTOS needs.

Connection TemplatesUpdated
Platform
Dell
On this page

Dell connection templates

The dell/ folder holds four templates for three Dell switch families, all Core and Pro. This page covers release v2.2.2. The folder has no README; what follows comes from the template files and their header comments.

Which template

Template Use for
dell-ftos-ssh-enable Force10 FTOS (Dell Networking OS9) over SSH, with enable
dell-networking-ssh-noenable Dell Networking switches over SSH, account already privileged
dell-powerconnect-telnet-enable PowerConnect over telnet, with enable
dell-powerconnect-telnet-noenable PowerConnect over telnet, without enable

FTOS and the command line ending

FTOS ignores a command that ends in a bare carriage return, which is what rConfig sends after login unless told otherwise. The FTOS template sets commandLinebreak: "n" so commands go out with a newline instead.

That key needs rConfig Pro V8.4.0 or Core 8.2.19 or later. Older versions ignore it without an error, and the symptom is distinctive: login and enable succeed, then every show command times out or comes back empty. Login itself is unaffected, because the login steps always send a newline.

The templates

rConfig-templates / dell /dell-ftos-ssh-enable.ymlView on GitHub
Protocol
SSH, port 22
Enable
on
Line ending
commandLinebreak: n
Status
untested-starter
rConfig-templates / dell /dell-networking-ssh-noenable.ymlView on GitHub
Protocol
SSH, port 22
Enable
off
Paging
terminal length 0
Status
community-tested
rConfig-templates / dell /dell-powerconnect-telnet-enable.ymlView on GitHub
Protocol
Telnet, port 23
Enable
on
Paging
terminal length 0
Status
community-tested
rConfig-templates / dell /dell-powerconnect-telnet-noenable.ymlView on GitHub
Protocol
Telnet, port 23
Enable
off
Paging
terminal datadump
Status
community-tested

Device record setup

The FTOS and Dell Networking templates expect a Login: username prompt rather than Username:, and PowerConnect expects User:. If your firmware shows a different prompt at login, change the auth.username pattern in your copy of the template.


Type to search.